Morrill 337 Display

To use the large flat-screen display in Morrill 337 follow these directions:

# Find the appropriate cable (HDMI, VGA, or DVI) and run the cable carefully so that it will not be pulled or damaged. 
# If you need an adaptor, attach the adaptor to the CABLE first, before connecting to your computer.  
# Connect via HDMI (preferred) or VGA. If the last person using the display was using the same source and did not power off the display, it may simply turn on.
# If the display does NOT turn on automatically:
## Find the control on the back of the display at the lower, right-hand corner: it is a small square joystick in a recessed ring. Press the joystick in momentarily (click it) and the display should turn on.
## If it set to the wrong source, click the joystick again to display a directional menu, go RIGHT to select Source and click again.  A row of sources will be available along the top.  Move left or right to select the appropriate source and click to accept.
# After you're finished, disconnect the cable. The display will turn off by itself after a few minutes. Or you can power it off using the directional menu: go down and click.

Before you leave, please dress the cables nicely over the hook for the next person. 

Note: The remote is in the office of Steven Brewer (5-2272) if you need to access some setting not available via the menus.