Morrill 337 Display

From BCRCWiki

(Difference between revisions)
Jump to: navigation, search
(first draft)
Line 1: Line 1:
To use the large flat-screen display in Morrill 337 follow these directions.
To use the large flat-screen display in Morrill 337 follow these directions.
-
Connect via HDMI (preferred) or VGA. If the last person using the display was using the same source, the display may simply turn on.
+
Find the appropriate cable (HDMI, VGA, or DVI) and run the cable carefully so that it will not be pulled or damaged.
 +
 
 +
If you need an adaptor, attach the adaptor to the CABLE first, before connecting to your computer. 
 +
 
 +
Connect via HDMI (preferred) or VGA. If the last person using the display was using the same source and did not power off the display, it may simply turn on.
If the display does NOT turn on automatically, find the control on the back of the display at the lower, right-hand corner: it is a small square joystick in a recessed ring. Press the joystick in momentarily (click it) and the display should turn on.
If the display does NOT turn on automatically, find the control on the back of the display at the lower, right-hand corner: it is a small square joystick in a recessed ring. Press the joystick in momentarily (click it) and the display should turn on.
If it set to the wrong source, click the joystick again to display a directional menu, go RIGHT to select Source and click again.  A row of sources will be available along the top.  Move left or right to select the appropriate source and click to accept.
If it set to the wrong source, click the joystick again to display a directional menu, go RIGHT to select Source and click again.  A row of sources will be available along the top.  Move left or right to select the appropriate source and click to accept.
 +
 +
The display will turn off by itself after a few minutes. Or you can power it off using the directional menu: go down and click.
 +
 +
Please dress the cables nicely over the hook for the next person.
 +
 +
Note: The remote is in the office of Steven Brewer (5-2272) if you need to access some setting not available via the menus.

Revision as of 13:40, 25 September 2017

To use the large flat-screen display in Morrill 337 follow these directions.

Find the appropriate cable (HDMI, VGA, or DVI) and run the cable carefully so that it will not be pulled or damaged.

If you need an adaptor, attach the adaptor to the CABLE first, before connecting to your computer.

Connect via HDMI (preferred) or VGA. If the last person using the display was using the same source and did not power off the display, it may simply turn on.

If the display does NOT turn on automatically, find the control on the back of the display at the lower, right-hand corner: it is a small square joystick in a recessed ring. Press the joystick in momentarily (click it) and the display should turn on.

If it set to the wrong source, click the joystick again to display a directional menu, go RIGHT to select Source and click again. A row of sources will be available along the top. Move left or right to select the appropriate source and click to accept.

The display will turn off by itself after a few minutes. Or you can power it off using the directional menu: go down and click.

Please dress the cables nicely over the hook for the next person.

Note: The remote is in the office of Steven Brewer (5-2272) if you need to access some setting not available via the menus.

Personal tools